SU-P-024-RevA, 1/4/2021
Page 1 of 5
ST4500 Quick Start Guide
Connect, Configure and Assemble
Figure 1: ST4500
1. Scope: Focused initial steps to quickly connect the ST4500 to a PC, configure Network Parameter settings using
SyncTrak and assemble for use. For detailed specifications and programming information please see the Related
Suntech Documentation links below or contact Suntech Support at support@suntechus.com
.
2. Related Suntech Documentation:
a. Suntech ST4500 Documentation
b. ST4000 Series SIM Card Information
c. ST4000 Series-LED Activity and Diagnostic Guide
d. SyncTrak User Manual
3. Required Resources:
a. HW: Suntech ST4500, 4 assembly screws, USB to Micro-USB cable
b. HW: SIM card: Activated, Access Point Name (APN) for carrier/network
c. HW: PH#1 or PH#2 Screwdriver (Torque Driver recommended)
d. HW: PC Computer: Windows 10 recommended
e. HW (optional): OBD2 port connector providing 12vDV
f. SW: Suntech USB Driver: v1.1032.3 or newer, available at support@suntechus.com
g. SW: Suntech SyncTrak: v5.0.6.5 or newer, available at support@suntechus.com
4. Connect the ST4500 to a PC
a. Remove the ST4500 lid marked “ST4500 OBD Tracker” to access SIM card holder, Micro-USB and backup
battery connectors, see Figure 2.
Figure 2: Remove ST4500 lid
To Next Page
Need help?
General
