Need help?Do you have a question about the Sunwave CrossFire M2 and is the answer not in the manual?
Steps for verifying the correct installation and connection of the Access Unit.
Steps for verifying the correct insertion and connection of optical transceivers.
Steps for verifying the correct installation and connection of PA modules.
Steps to set up wired access to the OMT on the Master A2 using IP properties.
Steps to set up wired access to the OMT on slave devices using IP properties.
Details the login process, credentials, and access levels for user accounts.
How to adjust gain using manual or automatic modes for the A2.
How to input attenuation values for UL and DL on the digital board.
Steps to set attenuation in M2RU by inputting UL and DL values.
How to set up and configure alarm severity levels and thresholds.
How the Master A2 manages software upgrades for the entire system.
Procedure for performing local system software upgrades on M2RU or E2 units.
To Next Page
General