28
The LED cannot wake up during
system operation
1. If the LED is off, the POWER
button is faulty or the button
wiring is loose
2. If the LED still does not light up
after restarting, the LED is faulty
Please contact the supplier to repair or
replace the control module
Abnormal battery
communication
Communication disconnection Check whether the battery stack is
installed reliably.
The heater works abnormally Heating circuit failure Log in to the PowerLite APP to view
the fault information and contact the
supplier
Abnormal Bluetooth
connection
bluetooth account connect error Check whether the paired Bluetooth is
consistent with the installed product
The inverter is powered on for
the first time through the
battery, and the battery
reports short-circuit protection
The parallel capacitor value of the
input terminal on the battery side
of the inverter is large
Battery protection can be
automatically restored
Inverter won't start The battery voltage is too low or
the SOC is lower than the
shutdown protection value
Charge the battery after starting the
inverter from the grid
6 Warehouse storage guidelines
6.1 Packaging guidelines
Lithium-ion batteries is recognized as dangerous goods. The packaging requirements for battery
products are as follows:
a. The packaging manufacturer with the packaging qualification for dangerous goods is
responsible for providing product packaging, and the packaging manufacturer has a record in
the local Commodity Inspection Bureau;
b. After the packaging manufacturer completes the packaging, the supplier needs to apply to the
Commodity Inspection Bureau, and the Commodity Inspection Bureau will provide the
"Dangerous Package Product Use Inspection Sheet" and
c. "Dangerous package product performance inspection sheet", and complete the dangerous
package commodity inspection;
d. All battery packs should be packaged with product instruction manuals. The packaged product
should be placed in a dry, dust-proof and moisture-proof packing box;
e. The product name, model, quantity, gross weight, manufacturer, and ex-factory date should
be marked on the outside of the packing box.
f. The necessary signs such as "upward" and "fear of fire" shall meet the requirements of GB/T
191;
g. The packing method is: packing in a carton with molded foam buffer material in the carton;
h. Accessories packaging: single accessories are first fastened with cardboard or plastic film or
braided straps, neatly placed in the carton, and filled with regular fillers (foam pads, cardboard,
etc.) to prevent the accessories from shifting in the box. The following documents should be
included with the product when leaving the factory:
To Next Page
Loading...