SuperMax FT 9950 Power Plus - Software Upgrade via Serial Port

PROBLEM SOLUTION
DiSEqC 1.0
• Check that you have connected the LNBs to correct
connections on the switch.
• Check that you have set the connected Setting in the
Installation menu.
The front panel does not
display the time.
DiSEqC 1.2
• Check that you have selected this in the Installation
menu.
• Check that the dish is aimed at the correct satellite.
• Make sure you have switched on the STB.
• Switch the STB on and turn to a service to allow the STB
to receive the time sent with the signal by the service
Time displayed on the front
panel is incorrect.
to
receive
the
time
sent
with
the
signal
by
the
service
provider.
• Front panel will only display the time in Standby mode.
• Adjust the time in the Time Settings menu.
12