3-1
Chapter 3
Installation
3-1 Hardware Installation
User the directions below to install the AOC-UIBQ-m1/m2 add-on card into your server
system.
Before Installation
Before Installation, do the following
1. Power down the system.
2. Remove the power cord from the wall socket.
3. Use industry standard anti-static equipment (i.e. gloves or wrist strap) and/or an
environment that prevents accidental electrostatic discharge.
4. Familiarize yourself with the server, motherboard, and/or chassis documentation.
5. Confirm that your Operating System includes the latest updates and hot-fixes.
Installation
The AOC-UIBQ-m1/m2 add-on card can be either installed using a riser card or directly
in a UIO slot directly in the system.
If installed directly in the UIO slot, use the procedure below. When using a riser card,
simply connect the AOC-UIBQ-m1/m2 add-on card to the riser card and install the riser
card into the designated slot on the mainboard.
Installing the Add-on Card
1. Remove the server cover and, if necessary, set aside any screws for later use.
2. Remove the add-on card slot cover. If the case requires a screw, place the screw
aside for later use.
3. Position the add-on card in the slot directly over the connector and gently push
down on both sides of the card until it slides into the PCI connector.
NOTE: This card is designed for UIO (Supermicro's Universal I/O) servers and
motherboards only.
NOTE: The AOC-UIBQ-m1/m2 add-on card can be configured as either a
standard or low-profile card depending upon the bracket used.
To Next Page
Loading...
Need help?
General
