Supermicro AOC-UIBQ-m1 User Manual

3-3
Chapter 3: Installation
Installing InfiniBand Drivers for the Windows Operating System
1. From the CDR-NIC LAN driver CD or FTP site, go to the following directory:
M
ELLANOX Æ INFINIBAND Æ WINDOWS.
2. Choose the desired InfiniBand Windows driver package file.
3. Double-click to run and install the driver package file.
Installing 10G Drivers for the Windows Operating System
1. From the CDR-NIC LAN driver CD or FTP site, go to the following directory:
M
ELLANOX Æ CONNECTX_EN Æ WINDOWS.
2. Choose the desired 10G Windows driver package file.
3. Double-click to run and install the driver package file.
Firmware Update Procedures
Use the following procedures for updating the AOC-UIBQ-m1/m2 add-on card firmware
for both the Linux and Windows operating systems.
Updating Firmware for the Linux Operating System
1. From the CDR-NIC LAN driver CD or FTP site, go to the following directory:
M
ELLANOX Æ FIRMWARE_TOOL Æ LINUX.
2. Choose the MFT Linux package file and untar the package file.
3. Install the package by the following command:
cd mft-<ver>
./install.sh
4. Install the firmware by the following commands:
mst start
mst status *note down the pci_cr0 device name*
flint –d <pci_cr0 device name> -i <firmware file name>.bin
b
Upadating Firmware for the Windows Operating System
1. From the CDR-NIC LAN driver CD or FTP site, go to the following directory:
M
ELLANOX Æ FIRMWARE_TOOL Æ WINDOWS.
2. Choose the desired MFT Windows package file.
3. Double-click to run and install the MFT package file.
4. Open up the DOS Command Prompt and locate the MFT folder.
5. Install the firmware by the following commands:
mst start
mst status *note down the pci_cr0 device name*

Supermicro AOC-UIBQ-m1 Specifications

General

Brand	Supermicro
Model	AOC-UIBQ-m1
Category	Computer Hardware
Language	English