AOC-UIBQ-m1/m2 Add-on Card User’s Manual
3-2
4. Secure the add-on card to the chassis. If required, use the screw that you previously
removed.
5. Replace the chassis cover.
6. Connect the incoming QSFP cable to the QSFP port provided on the card.
7. Plug the power cord into the wall socket and power up the system.
3-2 Installing Drivers and Firmware
Use the procedures below to install both drivers and firmware for the AOC-UIBQ-m1/m2
add-on card for both Linux and Windows.
Linux Drivers
Use the following procedures for installing AOC-UIBQ-m1/m2 add-on card drivers for
the Linux operating system.
Installing InfiniBand Drivers for the Linux Operating System
1. From the CDR-NIC LAN driver CD or FTP site, go to the following directory:
M
ELLANOX Æ INFINIBAND Æ LINUX.
2. Choose the InfiniBand Linux driver package file.
3. Install the driver by the following commands:
tar xzvf OFED-<ver>.tgz
cd OFED-<ver>
./install.pl
This installs the Linux drivers to your system.
Installing 10G Drivers for the Linux Operating System
1. From the CDR-NIC LAN driver CD or FTP site, go to the following directory:
M
ELLANOX Æ CONNECTX_EN Æ LINUX.
2. Choose the 10G Linux driver package file.
3. Install the driver by the following commands:
tar xzvf mlnx_en-<ver>.tgz
cd mlnx_en-<ver>
./install.sh
This installs the 10G drivers to your system.
Windows Drivers
Use the following procedures for installing AOC-UIBQ-m1/m2 add-on card drivers for
the Windows operating system.
To Next Page
Loading...
Need help?
General
