Supermicro C7Z170-OCE - Network Stack

4-60
Supermicro C7Z170-OCE Motherboard User’s Manual
PCIe/PCI/PnP Conguration
PCI/PCIX/PCIe Slot1 OPROM,
PCI/PCIX/PCIe Slot2 OPROM,
PCI/PCIX/PCIe Slot3 OPROM,
PCI/PCIX/PCIe Slot4 OPROM,
PCI/PCIX/PCIe Slot5 OPROM
Select Disabled to deactivate the selected slot, Legacy to activate the
slot in legacy mode and EFI to activate the slot in EFI mode. The op-
tions are Disabled, Legacy, and EFI.
Onboard LAN Option ROM type
Select the type of option ROM installed. The options are Legacy and
UEFI.
Onboard LAN1 Option ROM
Select PXE (Preboot Execution Environment) to boot the computer
using a PXE device installed in a LAN port specied. Select Disabled
to prevent system boot using a device installed in a LAN port. The
options are Disabled and PXE.
Onboard LAN2 Option ROM
Select PXE (Preboot Execution Environment) to boot the computer
using a PXE device installed in a LAN port specied. Select Disabled
to prevent system boot using a device installed in a LAN port. The
options are Disabled and PXE.
Network Stack
Select Enabled to enable PXE (Preboot Execution Environment) or UEFI
(Unied Extensible Firmware Interface) for network stack support. The
options are Disabled and Enabled. If this feature is enabled, the two
features below are available.
Ipv4 PXE Support
Select Enabled to enable Ipv4 PXE (Preboot Execution Environ-
ment) for boot support. If this feature is set to Disabled, Ipv4
PXE boot option will not be supported. The options are Disabled
and Enabled.
Ipv6 PXE Support
Select Enabled to enable Ipv6 PXE (Preboot Execution Environ-
ment) for boot support. If this feature is set to Disabled, Ipv6
PXE boot option will not be supported. The options are Disabled
and Enabled.