Chapter 2: Installation
2-9
JBR1
S5S10
S6
S9S7
SP1
48
B1
JBT1
JSTBY1
JD1
OC_FRONT_PANEL
JF1
1
2
1516
JSD1
FAN5
FAN1
FAN4
FAN2
FAN3
S8
S11
JTPM1
1
1
13
LED2
A
JPW2
JL2
JI2C2
JI2C1
JSPDIF_OUT
JL1
LED4
MH12
MH11
MH10
JVR1
JPL2
JLED1
JPAC1
JPL1
JWD1
JPME2
C7Z170-OCE
REV:1.00
BIOS
LICENSE
MAC CODE
BAR CODE
LAN2
0/1
PCIE M.2 CONNECTOR
USB10(3.1)
LED
PWR NIC
LED
HDD
OH/FF
1
RST
X
ON
PWR
USB8/9(3.0)
USB6/7(3.0)
LAN1
I-SATA4
I-SATA5
BIOS Restore
CLEAR CMOS
KB/MOUSE USB
USB2/3
USB4/5
USB11/12(3.1)
I-SATA1
I-SATA3
I-SATA2
DIMMB2
DIMMB1
DIMMA2
DIMMA1
HDMI/DP/SPDIF
PCH SLOT1 PCI-E 3.0 X1 (IN X4)
CPU SLOT2 PCI-E 3.0 X16
PCH SLOT3 PCI-E 3.0 X1 (IN X4)
CPU SLOT4 PCI-E 3.0 X8 (IN X16)
CPU SLOT6 PCI-E 3.0 X16
CPU FAN
AUDIO FP
HD AUDIO
JF1
ALWAYS POPULATE GREEN SOCKET FIRST
UNB NON-ECC DDR4 DIMM REQUIRED
COM1
DVI
LED1
S12
I-SATA0
JPW1
DESIGNED IN USA
CPU Socket LGA1151
PCH
Z170
2
NIC
2-4 Installing DDR4 Memory
Note: Check the Supermicro website for recommended memory
modules.
Attention! Exercise extreme care when installing or removing
DIMM modules to prevent any possible damage.
DIMM Installation
1. Insert the desired number of
DIMMs into the memory slots,
starting with DIMMB2, DIMMA2,
then DIMMB1, DIMMA1 (see the
layout for the location). For the
system to work properly, please
use the memory modules of
the same type and speed in the
same motherboard.
Release Tabs
Notches
2. Push the release tabs outwards
on both ends of the DIMM slot
to unlock it.
Press both notches
straight down into
the memory slot.
3. Align the key of the DIMM mod-
ule with the receptive point on the
memory slot.
4. Align the notches on both ends of
the module against the receptive
points on the ends of the slot.
5. Use two thumbs together to press
the notches on both ends of the
module straight down into the slot
until the module snaps into place.
6. Press the release tabs to the lock
positions to secure the DIMM mod-
ule into the slot.
Removing Memory Modules
Reverse the steps above to remove the
DIMM modules from the motherboard.
To Next Page
Loading...
