Supermicro C9Z490-PG - Page 110

Super C9Z490-PG/-PGW User's Manual
110
Disable Turbo GT frequency
This feature disables Turbo GT frequency. If set to Enabled, Turbo GT frequency be-
comes disabled. If set to Disabled, GT frequency limiters will be removed.The options
are Disabled and Enabled.
SATA And RST Conguration
SATA And RST Conguration
SATA Controller(s)
This feature enables SATA device(s). The options are Disabled and Enabled.
*If this feature is set to Enabled, the following features will become available for
conguration:
SATA Mode Selection
This feature controls SATA mode(s). The options are AHCI and Intel RST Premium With
Intel Optane System Acceleration .
*If this feature is set to Intel RST Premium With Intel Optane System Acceleration,
the following features will become available for conguration:
SATA Interrupt Selection
Select which interrupt will be available to the OS. The options are Msix, Msi, and Legacy.
PCI-E M.2-M1/PCI-E M.2-M2
This feature appears if an M.2 device is plugged in and RAID is selected in the SATA Mode
Selection feature. Use this feature to enable or disable RST PCIe storage remapping. The
options are RST Controlled and Not RST Controlled.
Note: The feature shown here is depending on the scoket of M.2 device plugged into
the motherboard.
RAID Device ID
Use this feature to select a RAID device ID. The options are iRST Mode and Alternate.
Storage Option ROM/UEFI Driver
This feature controls the execution of UEFI and legacy storage OpROM. The options are Do
not launch, UEFI, and Legacy.
Teton Glacier Mode
Use this feature to select Teton Glacier Mode. The options are Dynamic Conguration for
Hybrid Storage Device Enable and Disabled.
Note: This feature becomes congurable when the RAID Device ID is set to iRST Mode.