Supermicro C9Z490-PG - Page 89

Chapter 4: UEFI BIOS
89
RcompTarget[RdOdt]
RcompTarget[WrDS]
RcompTarget[WrDSCmd]
RcompTarget[WrDSCtl]
RcompTarget[WrDSClk]
DllBwEn[0]
DllBwEn[1]
DllBwEn[2]
DllBwEn[3]
Enter a desired numeric value above for each feature. The default of these features is 0.
Load line Calibration
This feature controls the load line calibration. The options are Disabled, Level 1, Level 2,
Level 3, Level 4, Level 5, Level 6, Level 7, and Auto.
Core Voltage Mode
This feature controls the core voltage mode. The options are Adaptive and Override.
VF Point O󰀨set Mode
Use this feature to select Legacy or Selection mode. The options are Legacy and Selection.
*If the feature above is set to Legacy, the following features will become available for
conguration:
Core Voltage O󰀨set
Enter a value for the o󰀨set voltage (in mV) that will be applied to the IA Core domain. The
default is Auto.
O󰀨set Prex
Use this feature to set the prex value as a positive (+) or a negative (-). The options are
“+” and “-”.
Note: If there is any change to this setting, you will need to power o󰀨 and reboot the
system for the change to take e󰀨ect.
Core Extra Turbo Voltage
Enter a numeric value for the extra turbo voltage (in mV) that will be applied while IA Core
is operating in turbo mode. The default is Auto.