Supermicro H11DSi - Page 73

Chapter 4: BIOS (EPYC 7001 Series)
73
Network Stack Conguration
Network Stack
This setting allows you to Enable or Disable the UEFI Network Stack.
Ipv4 PXE Support
This setting allows you to Enable or Disable IPv4 PXE boot support. If disabled, IPv4 PXE
boot support will not be available.
Ipv4 HTTP Support
This setting allows you to Enable or Disable IPv4 HTTP boot support. If disabled, IPv4 HTTP
boot support will not be available.
Ipv6 PXE Support
This setting allows you to Enable or Disable IPv6 PXE boot support. If disabled, IPv6 PXE
boot support will not be available.
Ipv6 HTTP Support
This setting allows you to Enable or Disable IPv6 HTTP boot support. If disabled, IPv6 HTTP
boot support will not be available.
PXE Boot Wait Time
This setting allows you to set in a number eld the wait time to press the ESC key to abort
the PXE boot. Default is 0.
Media Detect Count
This setting allows you set in a number eld the number of times presence of media will be
checked. Default is 1.
SATA Conguration
This section displays the detected SATA devices installed on the system.
SATA Controller
This setting enables or disables the on chip SATA controller. The options are Enabled,
Disabled or Auto.
SATA Hot Plug
This setting enables or disables the on chip SATA hot plug feature. The options are Enabled,
Disabled.