Supermicro H13SAE-MF - Page 75

Chapter 4: BIOS
75
PXE Boot Wait Time
This setting allows you to set in a number eld the wait time to press the ESC key to abort
the PXE boot. The default value is 0.
Media Detect Count
This setting allows you set in a number eld the number of times presence of media will be
checked. The default value is 1.
MAC: 7CC2554B3118-IPv4 Network Conguration
Congured
Indicae whether network address congured successfully or not. The options include
Disabled and Enabled.
MAC: 7CC2554B3118-IPv6 Network Conguration
Enter Conguration Menu
Interface Name
Interface Type
MAC address
Host address
Route Table
Gateway addresses
DNS addresses
Interface ID
The 64-bit alternative interface ID for the device. The string is colon separated. The
default setting is 7E:C2:55:FF:FE:4B:31:18.
DAD Transmit Count
The number of consecutive neighbor solicitation messages sent while performing dupli-
cate address detection on a tentative address. A value of zero indicates that duplicate
address detection is not performed. The default value is 1.
Policy
The options are automatic and manual.