Chassis SC743 User's Manual
26
Chapter 3
Maintenance and Component Installation
This chapter provides instructions on installing and replacing main system components. To
assure compatibility, only use components that match the specications or part numbers given.
Installation or replacement of most components require that power rst be removed from the
system.
3.1 Removing Power
Use the following procedure to ensure that power has been removed from the system. This
step is necessary when removing or installing non-hot-swap components.
1. Use the operating system to power down the system.
2. After the system has completely shut down, disconnect both the AC power cords from the
power strip or outlet.
3. Disconnect the power cords from both the power supply modules.
To Next Page
Loading...
