Supermicro SSE-G3748 Series - Chapter 3: Installation and Setup; 3.1 SONIC Model Installation and Configuration

28
Chapter 3: Installation and Setup
Chapter 3
Installation and Setup
This chapter covers the setup of SSE-G3748 series Ethernet switches.
3.1 SSE-G3748/D/R/DR-SONIC
Installation
To install SSE-G3748 series Ethernet switches use the procedure below.
Installing the Switch
1. Carefully unpack the switch from its shipping container and verify that all parts are
present.
2. Install the rail kit onto the side of the switch using a screwdriver.
3. Mount the switch into your rack assembly.
Conguring the Switch Module
The SSE-G3748/D/R/DR-SONIC Ethernet switch can be congured directly through a
command line interface (using the SSH interface or the serial console).
The management utility accesses the switch directly using the command line interface.
Any port may be congured as up (active) or down (inactive). All ports are active by default.