Supermicro SSE-G3748 Series - Installing the Switch into the Rack

Appendix A: Rack Installation
48
Installing the Switch into a Rack
Use this procedure to install the switch into a rack.
Warning: Mounting the system into the rack requires at least two people to support the
chassis during installation. Please follow the safety recommendations printed on the rails.
Installing the Switch into a Rack
1. Test the t of the switch in the rack by sliding the inner rails secured to the switch into
the outer rails secured to the rack. Adjust as necessary.
2. Once adjustments are made, tighten and lock down all the M5 screws on the outer rail
to the rack, and slide the switch in place.
3. Secure the inner rail to the rack with the M5 screws.
M5 Screws