Supermicro SSE-G48-TG4 - Time Management

Supermicro L2/L3 Switches Configuration Guide
32
Step 3
storm
-
control { broadcast |multicast | dlf } level
<pps-rate-value (1-10000000)>
Configure
s
torm control for broadcast
,
multicast or DLF packets.
Level – threshold level in packets per
second from 1-10000000.
Step 4
end
Exits the configuration mode.
Step 5
show interfaces storm
-
control
Displays the
i
nterface
s
torm control
configuration.
Step 6
write
startup
-
config
Optional step
–
saves this configuration
to be part of the startup configuration.
The
“
no storm
-
control { broadcast |multicast | dlf } level
”
command
disables
s
torm
control.
The example below shows the commands used to configure storm control.
SMIS# configure terminal
SMIS(config)# interface Gi 0/22
SMIS(config-if)# storm-control broadcast level 50000
SMIS(config-if)# end
SMIS# show interfaces Gi 0/22 storm-control
Gi0/22
DLF Storm Control: Disabled
Broadcast Storm Control: Enabled
Broadcast Storm Control: 50000
Multicast Storm Control: Disabled
1.5 Time Management
The system time and date on Supermicro switches can be managed by Network Time Protocol (NTP) or
configured manually.
NTP provides synchronization of network resources by a synchronized network timestamp. Supermicro
switches can function as a NTP client over UDP and receive the time from an NTP server in the network.
The time
Defaults – Time Management
Parameter Default Value