Supermicro SSE-G48-TG4 - Console Log

Supermicro L2/L3 Switches Configuration Guide
54
LogBuffer(0 Entries)
LogFile(0 Entries)
1.7.3 Console Log
System Logging messages can be displayed in the switch console.
Follow the steps below to enable the Syslog console.
Step Command Description
Step 1
configure terminal
Enters the configuration mode
.
Step 2
logging console
Enable
s
Syslog
c
onsole.
Step 3
e
nd
Exits the configuration mode.
Step 4
show
logging
Displays the
Syslog
configuration.
Step 5
write startup
-
config
Optional step
–
saves this configuration
to be part of the startup configuration.
The
“
no
logging console
”
command
disables
c
onsole
l
ogging
.
The example below shows the commands used to enable the Syslog console.
SMIS# configure terminal
SMIS(config)# logging console
SMIS(config)# end
SMIS# show logging
System Log Information
----------------------
Syslog logging: enabled(Number of messages 0)
Console logging: enabled(Number of messages 0)
File logging: disabled(Number of messages 0)
Log File Name:
File Max Entries: 500
TimeStamp option: enabled
Trap logging: Critical
Log server IP: None
Facility: Default (local0)
Buffered size: 50 Entries
LogBuffer(0 Entries)
LogFile(0 Entries)