Supermicro SSE-G48-TG4 - Page 46

Supermicro L2/L3 Switches Configuration Guide
46
interface <interface
-
type> <iface> [status {
permanent | deleteOnReset | deleteOnTimeout }]
p
hysical ports or port
channels.
Interface-type - may be any of the
following:
gigabit ethernet – gi
extreme-ethernet – ex
qx-ethernet – qx
vlan
Port Channel
interface-id is in slot/port format for all
physical interfaces. It may be the VLAN
identifier for VLAN interfaces.
Forbidden-ports - Set of ports
forbidden for the VLAN.
Permanent – Static MAC address is not
deleted even after a switch reboot.
deleteOnReset – Static MAC address is
deleted on switch reset/reboot.
deleteOnTimeout - Static MAC address
is deleted along with dynamic MAC
entries after the aging time times out.
Step 3
end
Exits the configuration mode.
Step 4
show mac
-
address
-
table static multicast [vlan
<vlan-range>] [address <aa:aa:aa
:aa:aa:aa>] [{interface <interface-type> <interface-
id> }]
show mac-address-table static unicast [vlan <vlan-
range>] [address <aa:aa:aa:a
a:aa:aa>] [{interface <interface-type> <interface-
id> }]
Displays the
static MAC
configuration.
Step 5
write startup
-
config
Optional step
–
saves this configuration
to be part of the startup configuration.