Supermicro SSE-G48-TG4 - Page 60

Supermicro L2/L3 Switches Configuration Guide
60
Follow the steps below to configure the logging of traps.
Step Command Description
Step 1
configure terminal
Enters the configuration
mode
.
Step 2
logging trap [{ <level (0
-
7)> | alerts | criti
cal |
debugging | emergencies |errors |informational |
notification | warnings }]
Configure
s the l
ogging
of t
raps.
There are various levels of traps that
can be logged.
Level 0 – Emergencies
Used for logging messages that are
equivalent to a panic condition.
Level 1 – Alerts
Used for logging messages that require
immediate attention.
Level 2 – Critical
Used for logging critical errors.
Level 3 – Errors
Used for error messages.
Level 4 – Warning
Used for logging warning messages.
Level 5 – Notification
Used for logging messages that require
attention but are not errors.
Level 6 – Informational
Used for logging informational
messages.
Level 7 – Debugging
Used for logging debug messages.
Step 3
e
nd
Exits the configuration mode.
Step 4
show logging
Displays the
Syslog
configuration.
Step 5
write startup
-
config
Optional step
–
saves this configuration
to be part of the startup configuration.
The
“
no
logging trap
”
command
resets the
t
rap
l
ogging to its default value of ‘Critical’.