Supermicro SSE-G48-TG4 - Page 70

Supermicro L2/L3 Switches Configuration Guide
70
Step 3
end
Exits the configuration mode.
Step 4
show tacacs
Displays the TACACS configuration.
Step 5
write startup
-
config
Optional step
–
saves this configuration
to be part of the startup configuration.
The
“
no
tacacs
-
server retransmit
”
command
resets the TACACS server re
-
tries to its default
value.
The example below shows the commands used to configure the TACACS server re-tries.
SMIS# configure terminal
SMIS(config)# tacacs-server retransmit 5
SMIS(config)# end
1.8.3.3 TACACS Use-server
Supermicro switches provide an option to configure multiple TACACS servers. Users can specify one of
these available servers to be used at a time.
Follow the steps below to configure the TACACS server to be used.
Step Command Description
Step 1
configure terminal
Enters the configuration mode
.
Step 2
tacacs use
-
server address<ip
-
address>
Configure
s
TACACS server to be used.
Step 3
end
Exits the configuration mode.
Step 4
show tacacs
Displays the TACACS configuration.
Step 5
write startup
-
config
Optional step
–
saves this configuration
to be part of the startup configuration.
The
“
no
tacacs use
-
server address<ip
-
address>
”
command
deletes the TACACS client
.
The example below shows the commands used to configure the TACACS server to be used.
SMIS# configure terminal
SMIS(config)# tacacs use-server address 10.10.10.1
SMIS(config)# end
SMIS# show tacacs
Server : 1
Address: 10.10.10.1
Single Connection: no