7-1
Chapter 7
Switch Management
The SSE-X3348T/SSE-X3348TR switch includes a management agent that allows you
to configure or monitor the switch using its embedded management software. To
manage the switch, you can make a direct connection to the console port (out-of-band),
or you can manage it through a network connection (in-band) using Telnet, Secure Shell
(SSH), a web browser, or SNMP-based network management software.
7-1 Understanding the System Status LEDs
The switch includes a display panel of key system LED indicators (Figure 7-1). The
LEDs, which are located on the front panel, are shown below and described in the
following table.
Figure 7-1. System Status LEDs
Table 7-1. System Status LEDs
LED Condition Status
PSU1/PSU2
On Green Power supply 1/2 is installed and operating normally.
On Amber The power supply has detected a fault.
Off The power supply unit is not installed.
Diag
On Green The system diagnostic test has completed successfully.
On Amber The system self-diagnostic test has detected a fault.
Fan
On Green Fans are operating normally.
On Amber A fan failure has been detected.
To Next Page
Loading...
