8-2
Chapter 8: Troubleshooting
8-4 Installation
Verify that all system components have been properly installed. If one or more
components appear to be malfunctioning (such as the power cord or network cabling),
test them in an alternate environment where you are sure that all the other components
are functioning properly.
8-5 In-Band Access
You can access the management agent in the switch through a connection to any port
using Telnet, a web browser, or other network management software tools. However,
you must first configure the switch with a valid IP address, subnet mask, and default
gateway. If you have trouble establishing a link to the management agent, check to see
if you have a valid network connection. Then verify that you entered the correct IP
address. Also, be sure the switch port has not been disabled. If it has not been disabled,
then check the network cabling that runs between your remote location and the switch.
To Next Page
Loading...
Need help?
General
