18
SuperServer 5019A-FTN4 User's Manual
Warning: Stability hazard. The rack stabilizing mechanism must be in place, or the
stabilize the rack can cause the rack to tip over.
Figure 2-1. Installing the Chassis into a Rack
2.3 Installing the System into a Rack
This section provides information on installing the 505-203B chassis into a rack unit. Due to
to the installation instructions that came with the rack unit you are using.
Installing the Chassis into a Rack
The system can be directly installed into a rack using screws.
1. Gather the four mounting screws shipped with the system.
2. Align the mounting holes of the chassis with the through-holes of the rack.
3. Insert the mounting screws into the through-holes in the front of the chassis, and tighten
the screws until the chassis is secured to the rack.
To Next Page
Loading...
