Supermicro SuperServer 5019A-FTN4 - Control Panel

36
SuperServer 5019A-FTN4 User's Manual
Figure 4-1. JF1: Control Panel Pins
Control Panel


All JF1 wires have been bundled into a single cable to simplify this connection. Verify that
the red wire plugs into pin 1 as marked on the motherboard. The other end connects to the
control panel PCB board.
Power Button
OH/Fan Fail LED
NIC1 Activity LED
Reset Button
HDD LED
PWR LED
Reset
PWR
3.3V Stby
3.3V Stby
Ground
15
3.3V Stby
16
1 2
Ground
NIC2 Activity LED
Power Fail LED
UID
3.3V
3.3V
Power LED
The Power LED connection is located on pins 15 and 16 of JF1. Refer to the table below

Power LED
Pin Denitions (JF1)
Pins Denition
15 3.3V
16 PWR LED
HDD LED
The HDD LED connection is located on pins 13 and 14 of JF1. Attach a cable to pin 14 to

HDD LED
Pin Denitions (JF1)
Pins Denition
13 3.3V Stdby
14 HDD Active