Supermicro SuperServer 5019A-FTN4 - Installing 3.5 Fixed Hard Drives

25
SuperServer 5019A-FTN4 User's Manual
Figure 3-6. Two 3.5" HDDs and No Expansion Card
Installing 3.5" Fixed Hard Drives
You can install one 3.5" HDD and a PCI-E expansion card, or you can install two 3.5" HDDs
and no expansion card.
Installing 3.5" Hard Drives
Begin by removing power from the system as described in Section 3.1 and removing the
cover as described in Section 3.2.
1. Place the hard drives into the chassis as illustrated in Figure 3-5 or Figure 3-6. Orient
the drives with the cable connections facing the rear of the chassis.
2. 
underside of the chassis.
3. Connect the drive wiring.
4. Reinstall the chassis cover and restore power to the server.
Figure 3-5. One 3.5" HDD and One Low-Prole Expansion Card