Supermicro SuperServer 5019A-FTN4 - Page 90

90
SuperServer 5019A-FTN4 User's Manual
7. 󰀨
8. When a DOS prompt appears, enter FLASH.BAT BIOSname.### at the prompt.
9. After seeing the message indicating the BIOS update has completed, unplug the AC
power cable from the power supply, clear CMOS, then plug the AC power cable in the
power supply again to power on the system.
10. Press <Del> continuously to enter the BIOS Setup utility.
11. Press <F3> to load the default settings.
12. After loading the default settings, press <F4> to save the settings and exit the BIOS
Setup utility.
6. After the BIOS recovery process is completed, press any key to reboot the system.