Supermicro SuperServer 5019C-MHN2 - Hard Drive Carrier Indicators

SuperServer 5019C-MHN2 User's Manual
36
Removing a Drive from a Drive Carrier
1. Remove the screws that secure the hard drive to the carrier and separate the hard drive
from the carrier.
2. Replace the carrier back into the drive bay.
Hard Drive Carrier Indicators
Each hard drive carrier has two LED indicators: an activity indicator and a status indicator. In

󰀨
Figure 3-7. Removing a Drive Carrier
Note: Enterprise level hard disk drives are recommended for use in Supermicro chassis and
servers. For information on recommended HDDs, visit the Supermicro website at http://www.

Hard Drive Carrier LED Indicators
LED State/Condition Indication
Green Blinking Drive activity
Red Blinking Drive rebuilding
Red Solid on Drive failure