Supermicro SuperServer 5019C-MHN2 - Page 54

54
SuperServer 5019C-MHN2 User's Manual
Onboard Audio Enable/Disable
JPAC1 allows you to enable or disable the onboard audio support. The default position is on

Audio Enable/Disable
Jumper Settings
Jumper Setting Denition
Pins 1-2 Enabled (Default)
Pins 2-3 Disabled
Onboard TPM 2.0 Enable/Disable
Use JPT1 to enable or disable support for the onboard TPM 2.0 module. Refer to the table

TPM Enable/Disable
Jumper Settings
Jumper Setting Denition
Pins 1-2 Enabled (Default)
Pins 2-3 Disabled
Watch Dog
JWD1 controls the Watch Dog function. Watch Dog is a monitor that can reboot the system
when a software application hangs. Jumping pins 1-2 will cause Watch Dog to reset the
system if an application hangs. Jumping pins 2-3 will generate a non-maskable interrupt
signal for the application that hangs. Watch Dog must also be enabled in the BIOS. The
default setting is Reset.
Note: When Watch Dog is enabled, users need to write their own application software
to disable it.
Watch Dog
Jumper Settings
Jumper Setting Denition
Pins 1-2 Reset (Default)
Pins 2-3 NMI
Open Disabled