Chapter 6: BIOS
73
DMI Link ASPM Control
Use this feature to set the ASPM (Active State Power Management) state on the SA
(System Agent) side of the DMI Link. The options are Disable, L0s, L1, and L0sL1.
DMI Extended Sync Control
Use this feature to enable or disable the DMI extended synchronization. The options are
Enable and Disable.
DMI De-emphasis Control
and -3.5 dB.
PEG Port Conguration
CPU SLOT6 PCI-E 3.0 X16
SLOT6 Enable Root Port
Use this feature to enable or disable the PCI Express Graphics (PEG) device in the port
Auto.
SLOT6 Max Link Speed
Use this feature to select PCI-E support for the device installed on SLOT7. The options
are Auto, Gen 1, Gen 2, and Gen 3.
SLOT6 Power Limit Value
Use this feature to set the upper limit on the power supplied by the PCIE slot. Press "+"
or "-" on your keyboard to change this value. The default setting is 75.
SLOT6 Slot Power Limit Scale
Use this feature to select the scale used for the slot power limit value. The options are
1.0x, 0.1x, 0.01x, and 0.001x.
Program PCIe ASPM After OpROM
PCIe ASPM, the Active State Power Management for PCI-Express slots, is a power
management protocol used to manage power consumption of serial link devices installed
ASMP will be programmed after OPROM. If set to Disabled, the PCI-E ASPM will be
programmed before OPROM. The options are Disabled and Enabled.
To Next Page
Loading...
