Supermicro SuperServer 5019C-MHN2 - Page 78

SuperServer 5019C-MHN2 User's Manual
78

AST2500SEC Super IO Conguration
AST2500SEC Super IO Conguration
Super IO Chip AST 2500SEC
Serial Port 2 Conguration
Serial Port
Select Enabled to enable the selected onboard serial port. The options are Disabled and
Enabled.
Device Settings

Change Settings

 Auto to allow the BIOS to automatically assign the
base I/O and IRQ address. The options are Auto, (IO=248h; IRQ=10;), (IO=240h; IRQ=3,
4, 5, 6, 7, 10, 11, 12;), (IO=248h; IRQ=3, 4, 5, 6, 7, 10, 11, 12;), (IO=250h; IRQ=3, 4, 5, 6,
7, 10, 11, 12;), (IO=258h; IRQ=3, 4, 5, 6, 7, 10, 11, 12;), (IO=260h; IRQ=3, 4, 5, 6, 7, 10,
11, 12;), and (IO=268h; IRQ=3, 4, 5, 6, 7, 10, 11, 12;) .
COM Attribute
Use this feature to select the COM2 mode. The options are SOL and COM.

Serial Port Console Redirection
COM1/COM2/COM3/COM4
Console Redirection
Select Enabled to enable COM ports 1-4 for Console Redirection, which will allow a client
machine to be connected to a host machine at a remote site for networking. The options are
Disabled and Enabled.
*If the feature above is set to Enabled, the following features will become available for
conguration: