SuperServer 5019P-WT/WTR User's Manual
134
Appendix D: UEFI BIOS Recovery
135
8. Press <Del> continuously during system boot to enter the BIOS setup utility. From the
top of the tool bar, click on Boot and press <Enter> to enter the submenu. From the
submenu list, select Boot Option #1 as shown below. Then, boot Option #1 to [UEFI
AP:UEFI: Built-in EFI Shell]. Press <F4> to save the settings and exit the BIOS setup
utility.
9. When the UEFI Shell prompt appears, type fs# to change the device directory path. Go
to the directory that contains the BIOS package you extracted earlier from Step 7. Enter
Note: Do not interrupt this process
10. The screen above indicates that the BIOS update process is completed. When you
see the screen above, unplug the AC power cable from the power supply, clear CMOS,
and plug the AC power cable in the power supply again to power on the system.
11. Press <Del> continuously to enter the BIOS setup utility.
12. Press <F3> to load the default settings.
13. After loading the default settings, press <F4> to save the settings and exit the BIOS
setup utility.
6. After the BIOS recovery process is completed, press any key to reboot the system.
7.
progress as shown in the screen below.
Note: Do not interrupt the BIOS ashing process until it has completed.
5. When the screen as shown above displays, use the arrow keys to select the item
To Previous Page
Loading...
