Supermicro SuperServer 5029AP-TN2 - Page 20

20
SuperServer 5029AP-TN2 User's Manual
Figure 2-7. Installing the Expansion Card
4. Remove the screw that secures the PCI slot shield in the PCI slot at the rear of the tray
and set it aside for later use.
5. Slide the PCI slot shield up and out of the PCI slot.
6. Insert the card into its slot on the motherboard while aligning its bracket into the slot on
the chassis drawer.
7. Secure the bracket of the expansion card with the screw previously set aside.
8. Slide the rear tray into the chassis and secure it with the screws.
9. Replace the chassis cover and power up the system.
6
5