28
SuperServer 5029AP-TN2 User's Manual
Installing a Fan
The chassis includes a single 12-cm rear exhaust fan. The chassis also features a set of
mounting holes that will support a standard 9-cm exhaust fan (not included).
Installing the Exhasut Fan
1. Power down the system as described in Section 2.1 and remove the chassis cover.
2. Place the fan on top of the fan grill, aligning the mounting holes of the fan grill with the
mounting holes of the system fan.
3. Secure the fan to the chassis with four screws.
4. Connect the fan cable to the motherboard.
5. Replace the chassis cover, plug the power cord into the rear of the power supply and
power up the system.
Figure 2-17. Installing the Exhaust Fan
To Next Page
Loading...
