Supermicro SuperServer 5029AP-TN2 - Installing Expansion Cards

19
Chapter 2 Maintenance and Component Installation
Installing Expansion Cards
The 5029AP-TN2 includes a PCI slot for a low-prole expansion card. The card is installed
by removing the chassis tray that holds the motherboard and rear I/O shield.
Installing an Expansion Card
1. Power down the system as described in Section 2.1 and remove the chassis cover.
2. Remove the three screws securing the rear tray to the rear of the chassis and set them
aside for later use.
3. Pull the rear tray out from the chassis.
Figure 2-6. Removing the Rear Tray from the Chassis
3