Chapter 5: Advanced Serverboard Setup
5-5
Figure 5-1. Heatsinks
Figure 5-2. Heatsink Screw Order
Installing a Heatsink
1. Place the heatsink on top of the CPU so that the four mounting holes are aligned
with those on the retention mechanism.
2. Screw in two diagonal screws (#1 and #2) until just snug—do not over-tighten
and damage the CPU. Screw in the remaining screws.
3. Finish the installation by fully tightening all four screws.
Screw #1
Screw #2
Screw #3
Screw #4
Installing a CPU Heatsink
To Next Page
Loading...
