Chapter 5: Advanced Serverboard Setup
5-7
5-3 Connecting Cables
Now that the processors are installed, the next step is to connect the cables to the
serverboard. These include the data (ribbon) cables for the peripherals and control
panel and the power cables.
Connecting Data Cables
The cables used to transfer data from the peripheral devices have been carefully
air that moves through the system from front to back. If you need to disconnect any
of these cables, you should take care to reroute them as they were originally after
Connecting Power Cables
The X10DRU-i+ has a 4-pin primary power supply connector designated JPW1
for connection to the power supply. Connect the appropriate connector from the
power supply to JPW1 to supply power to the serverboard. See the Connector
Connecting the Control Panel
JF1 contains header pins for the front control panel connectors. All JF1 wires have
been bundled into single keyed ribbon cable to simplify their connection. The red
wire in the ribbon cable plugs into pin 1 of JF1. Connect the other end of the cable
to the Control Panel printed circuit board, located just behind the system status
LEDs in the chassis.
of JF1.
To Next Page
Loading...
