Supermicro SuperServer 6028U-TR4T+ - Removing the Chassis Cover

Chapter 6: Advanced Chassis Setup
6-3
6-3 Removing the Chassis Cover
1. 
straight out until it locks (you will hear a "click").
2. Remove the two screws on each side of the cover, which secure the cover to
the chassis.
3. Press the release tabs to remove the cover from the locked position. Press both
tabs at the same time.
4. Once the top cover is released from the locked position, slide the cover toward
the rear of the chassis.
5. 󰀨
6. To remove the system from the rack completely, press the locking tabs in the
chassis rails (push the right-side tab down and the left-side tab up) to continue
to pull the system out past the locked position. See Figure 6-2.
Figure 6-2. Accessing the Inside of the System
Remove
Screw
Remove
Screw
1
3
1
2
1
2
1
3
1
4
1
5