1-2
SUPERSERVER 6028U-T Series User's Manual
1-2 Motherboard Features
At the heart of the SuperServer 6028U-T Series lies the X10DRU-i+, a dual processor
motherboard based on the Intel PCH C612 chipset. Below are the main features of
the motherboard. (See Figure 1-1 for a block diagram of the chipset.)
Processors
The motherboard supports single or dual Intel E5-2600 v3 Series processors in
LGA2011 sockets (Socket R3). Refer to the Supermicro web site for a complete
listing of supported processors (www.supermicro.com).
Memory
The motherboard has 24 memory sockets that can support up to 768 GB of ECC
registered DDR4-1600/1333/1066/800 non-volatile RDIMM (Registered DIMMs)
or 1536 GB of LRDIMM (Load-Reduced DIMMs) DDR4-2133/1866/1600/1333
memory. Please refer to Chapter 5 for installing memory.
Onboard Serial ATA
A SATA controller is integrated into the chipset to provide a ten-port SATA
subsystem. Six of the ports are supported by the Intel PCH and four of the ports are
supported by the Intel SCU. The SATA 3.0 ports are connected to the backplane
by default. RAID 0, 1, 5 and 10 are supported by Intel RSTe Software RAID.
Rear I/O Ports
The rear I/O ports include one COM port, a VGA (monitor) port, two USB 3.0 ports
and a dedicated IPMI LAN port. In addition, there are several possible networking
Secion 1-1.
Graphics Controller
The motherboard features an integrated ASpeed 2400 BMC graphics chip.
To Next Page
Loading...
