Supermicro SuperServer 6048R-TXR - Page 63

Chapter 5: Advanced Serverboard Setup
5-17
Power Button
The Power Button connection is located
on pins 1 and 2 of JF1. Momentarily
contacting both pins will power on/off
the system. This button can also be
congured to function as a suspend
button (with a setting in the BIOS - See
Chapter 5). To turn off the power when
the system is in suspend mode, press
the button for 4 seconds or longer.
Refer to the table on the right for pin
denitions.
Power Button
Pin Denitions (JF1)
Pin# Denition
1 Signal
2 Ground
Serial Ports
Two COM (serial port connections: COM1 & COM2) are provided on the serverboard.
COM1 is located on the rear I/O panel. COM2, located close to PCI-E slot1, provides
front access support. See the table on the right for pin denitions.
Ethernet Ports
Two Gigabit Ethernet ports (LAN1, LAN2) are located on the rear I/O. These ports
support Gigabit LANs. In addition, a dedicated IPMI LAN is located above the USB
0/1 ports. All these ports accept RJ45 type cables. Please refer to the LED Indicator
Section for LAN LED information.
Chassis Intrusion
A Chassis Intrusion header is located
at JL1 on the serverboard. Attach an
appropriate cable from the chassis to
inform you of a chassis intrusion when
the chassis is opened.
Chassis Intrusion
Pin Denitions
Pin# Denition
1 Intrusion Input
2 Ground