Supermicro SuperWorkstation 7049GP-TRT - Page 35

35
Chapter 4: Motherboard Connections
Disk-On-Module Power Connector
The Disk-On-Module (DOM) power connectors at JSD1 and JSD2 provide 5V power to a
solid-state DOM storage devices connected to one of the SATA ports. See the table below

DOM Power
Pin Denitions
Pin# Denition
1 5V
2 Ground
3 Ground
Trusted Platform Module/Port 80 Header
Pin Denitions
Pin# Denition Pin# Denition
1 P3V3 2 SPI_TPM_CS_N
3 PCIE_RESET_N# 4 SPI_PCH_MISO
5 SPI_PCH_CLK# 6 Ground
7 SPI_PCH_MOSI 8 N/A
9 JTPM1_P3V3A 10 IRQ_TPM_SPIN_N
TPM Header
The JTPM1 header is used to connect a Trusted Platform Module (TPM)/Port 80, which is
available from a third-party vendor. A TPM/Port 80 connector is a security device that supports
encryption and authentication in hard drives. It allows the motherboard to deny access if the
TPM associated with the hard drive is not installed in the system. See the table below for

Chassis Intrusion
A Chassis Intrusion header is located at JL1 on the motherboard. Attach the appropriate cable
from the chassis to the header to inform you when the chassis is opened.
Chassis Intrusion
Pin Denitions
Pins Denition
1 Intrusion Input
2 Ground