38
SuperWorkstation 7049GP-TRT User's Manual
NVMe I
2
C Header
JNVI
2
C1 and JNVI
2
C2 are management headers for the Supermicro AOC NVMe PCI-E
peripheral cards. Please connect the I
2
C cable to the connector. Also, JNVI
2
C1 and JNVI
2
C2
are VPP headers for NVMe add-on cards on PCI-E slots 9 and 10 respectively.
Standby Power
The standby power header is located at JSTBY1 on the motherboard. Refer to the table
Standby Power
Pin Denitions
Pin# Denition
1 +5V Standby
2 Ground
3 No Connection
I/O Header for Thunderbolt
The JTBT1 header is a general purpose I/O header for a Thunderbolt add-on card.
PCI-E M.2 Connector (M.2 Connector)
The PCI-E M.2 connector is for devices such as memory cards, wireless adapters, etc. These
M.2 socket on the motherboard supports PCI-E 3.0 x4 (32 Gb/s) SSD cards in the 2280 and
22110 form factors.
NC-SI Header for IPMI Support
A Network-Controller Sideband Interface (NC-SI) header is located at JNCSI1 on the
motherboard. Connect an appropriate cable from this header to an add-on card to provide the
out-of-band (sideband) connection between the onboard Baseboard Management Controller
(BMC) and a Network Interface Controller (NIC) for remote management. For the network
sideband interface to work properly, you will need to use a motherboard that supports NC-SI
and also need to have a special cable. Please contact Supermicro at www.supermicro.com
To Next Page
Loading...
