SuperWorkstation 7049GP-TRT User's Manual
54
INT19 Trap Response
Interrupt 19 is the software interrupt that handles the boot disk function. When this item is
set to Immediate, the ROM BIOS of the host adaptors will "capture" Interrupt 19 at bootup
immediately and allow the drives that are attached to these host adaptors to function as
bootable disks. If this item is set to Postponed, the ROM BIOS of the host adaptors will not
capture Interrupt 19 immediately and allow the drives attached to these adaptors to function
as bootable devices at bootup. The options are Immediate and Postponed.
Re-try Boot
device after its initial boot failure. The options are Disabled, Legacy Boot, and EFI Boot.
Install Windows 7 USB support
Enable this feature to use the USB keyboard and mouse during the Windows 7 installation,
since the native XHCI driver support is unavailable. Use a SATA optical drive as a USB drive.
USB CD/DVD drives are not supported. Disable this feature after the XHCI driver has been
installed in Windows. The options are Disabled and Enabled.
Port 61h Bit-4 Emulation
Select Enabled to support the emulation of Port 61h bit-4 toggling in SMM (System
Management Mode). The options are Disabled and Enabled.
Power Conguration
Watch Dog Function
If enabled, the Watch Dog Timer will allow the system to reset or generate NMI based on
Disabled and
Enabled.
Restore on AC Power Loss
Use this feature to set the power state after a power outage. Select Stay-Off for
power to be turned on after a power loss. Select Last State to allow the system to
and Last State.
Power Button Function
This feature controls how the system shuts down when the power button is pressed. Select 4
as the user presses the power button. The options are Instant O and 4 Seconds Override.
To Next Page
Loading...
