Supermicro SuperWorkstation 7049GP-TRT - Page 75

SuperWorkstation 7049GP-TRT User's Manual
74
SATA RSTe Boot Info
Select Enable to provide the full int13h support for SATA controller attached devices. The
options are Disable and Enable.
SATA RAID Option ROM/UEFI Driver
Select EFI to load the EFI driver for system boot. Select Legacy to load a legacy driver for
system boot. The options are Disable, EFI, and Legacy.
SATA Port 0~ Port 7
This item displays the information detected on the installed SATA drive on the particular SATA
port.
• Model number of drive and capacity
• Software Preserve Support
Hot Plug (SATA Port 0~ Port 7)

Enable.
Spin Up Device (SATA Port 0~ Port 7)
On an edge detect from 0 to 1, set this item to allow the PCH to initialize the device. The
options are Disable and Enable.
SATA Device Type (SATA Port 0~ Port 7)

State drive or a Hard Disk Drive. The options are Hard Disk Drive and Solid State Drive.
PCH sSATA Conguration
sSATA Controller
This item enables or disables the onboard SATA controller supported by the Intel® PCH chip.
The options are Enable and Disable.
Congure sSATA as

AHCI and
RAID.
SATA HDD Unlock
Select Enable to unlock the HDD password. The options are Disable and Enable.