Supermicro X10SLH-LN6TF - Watch Dog Enable;Disable; Rear USB 4;5_Wake_Up Enable

2-34
X10SLH-LN6TF User’s Manual
A. Watch Dog Enable
B Rear USB4/5 Enable
A
Watch Dog Enable/Disable
Watch Dog (JWD1) is a system monitor that
can reboot the system when a software appli-
cation hangs. Close pins 1-2 to reset the sys-
tem if an application hangs. Close Pins 2-3 to
generate a non-maskable interrupt signal for
the application that hangs. See the table on
the right for jumper settings. Watch Dog must
also be enabled in the BIOS.
Watch Dog
Jumper Settings
Jumper Setting Denition
Pins 1-2 Reset (default)
Pins 2-3 NMI
Open Disabled
Rear USB 4/5_Wake_Up Enable
Set jumper JPUSB1 to Enabled to "wake up"
the system when a device installed in USB 4
or 5 receives a signal. See the table on the
right for jumper settings.
Rear USB 4/5 Wake_Up En-
able Jumper Settings
Jumper Setting Denition
Pins 1-2 Enabled (Default)
Pins 2-3 Disabled
B
A
IPMI CODE
CA
BIOS
LICENSE
BAR CODE
MAC CODE
CA
A
C
A
C
A
+
JLAN3
JLAN2
JLAN1
JP1000
JPW1
JPW2
JSTBY1
J4
LE6
DIMM1
DIMM2
DIMM4
DIMM3
FAN4
FAN3
FAN2
FAN1
FANA
JPME1
JI2C1
JPME2
JI2C2
JPUSB1
JPL1
JPL2
JPL3
JPG1
JBR1
JWD1
JLED1
LE5
LE4
LE1
LE3
J3
JL1
JLED_LAN4 JLED_LAN3
JLED_LAN6
JLED_LAN5
JPI2C1
JTPM1
T-SGPIO1
T-SGPIO2
JSD2
JSD1
SPKR1
B1
JBT1
JF1
SW1
COM1
COM2
PCH SLOT4 PCI-E 2.0 X4(IN X8)
DESIGNED IN USA
X10SLH-LN6TF
REV:1.01
USB0(3.0)
USB1(3.0)
USB12/13
USB8/9
CPU SLOT6 PCI-E 3.0 X8(IN X16)
I-SATA0
I-SATA2
I-SATA1
I-SATA3
I-SATA4
I-SATA5
VGA
LAN5/6
LAN3/4
LAN1/2
USB4/5 (2.0)
USB2/3(3.0)
JLED1:3 pin Power LED
IPMI LAN
JF1
NIC2
NIC1
ON
PWR
X
RST
OH/
FF
LED
LED
HDD
X
PWR
NMI
C226
X540
X540
X540
BMC
PLX