Supermicro X11DPU - Page 47

47
Chapter 2: Installation
1. NIC1 LED
2. NIC2 LED
3. Front UID LED
4. OH/Fan Fail LED
5. PWR Fail LED
1
2
3
Power Button
OH/Fan Fail LED
1
Reset Button
2
Power Fail LED
HDD LED
FP PWRLED
Reset
PWR
UID LED
Ground
Ground
19 20
3.3V
X
Ground
NMI
X
Vcc
Vcc
X
X NIC2 Activity LED
NIC1 Activity LED
UID/Overheat (OH)/Fan Fail
Connect an LED cable to UID/OH/Fan Fail connections on pins 7 and 8 of JF1 to provide
front UID LED indication and warnings for chassis overheat/fan failure. Refer to the table
below for pin denitions.
Power Fail LED
The Power Fail LED connection is located on pins 5 and 6 of JF1. Refer to the table below
for pin denitions.
NIC1/NIC2 (LAN1/LAN2)
The NIC (Network Interface Controller) LED connection for LAN port 1 is located on pin 12 of
JF1, and LAN port 2 is on pin 10. Attach the NIC LED cables here to display network activity.
Refer to the table below for pin denitions.
4
5
LAN1/LAN2 LED
Pin Denitions (JF1)
Pin# Denition
10 NIC2 Activity LED
12 NIC1 Activity LED
Reset Button
Pin Denitions (JF1)
Pin# Denition
7 Front UID LED
8 OH/Fan Fail LED
Power Fail LED
Pin Denitions (JF1)
Pin# Denition
5 3.3V
6 PWR Supply Fail