X11SSL-CF/-nF User Manual
72
Chapter 4
BIOS
4.1 Introduction
This chapter describes the AMIBIOS™ setup utility for the X11SSL-CF/X11SSL-nF
motherboard. The BIOS is stored on a Flash EEPROM and can be easily upgraded using a
ash program.
Note: Due to periodic changes to the BIOS, some settings may have been added
or deleted and might not yet be recorded in this manual. Please refer to the Manual
Download area of our website for any changes to BIOS that may not be reected in
this manual.
Starting the Setup Utility
To enter the BIOS setup utility, enter the <Delete> key while the system is booting up. (In
most cases, the <Delete> key is used to invoke the BIOS setup screen. There are a few
cases when other keys are used, such as <F1>, <F2>, etc.) Each main BIOS menu option
is described in this manual.
The main BIOS screen has two main frames. The left frame displays all the options that can
be congured. “Grayed-out” options cannot be congured. The right frame displays the key
legend. Above the key legend is an area reserved for a text message. When an option is
selected in the left frame, it is highlighted in white. Often a text message will accompany it.
Note that BIOS has default text messages built in. We retain the option to include, omit, or
change any of these text messages. Settings printed in Bold are the default values.
A "" indicates a submenu. Highlighting such an item and pressing the <Enter> key will
open the list of settings within the submenu.
The BIOS setup utility uses a key-based navigation system called hot keys. Most of these
hot keys (<F1>, <F4>, <Enter>, <ESC>, <Arrow> keys, etc.) can be used at any time during
the setup navigation process.
Note 1: Options printed in Bold are default settings.
Note 2: <F3> is used to load optimal default settings. <F4> is used to save the settings
and exit the BIOS setup utility.
To Next Page
Loading...
Need help?
General
