Chapter 4: BIOS
75
Warning: Take caution when changing the Advanced settings. An incorrect value, an inaccurate
DRAM frequency, or a wrong DRAM timing setting may make the system unstable. When this
occurs, revert the setting to the manufacture default settings.
Boot Feature
Quiet Boot
Use this feature to select the screen display between the POST messages and the OEM logo
upon bootup. Select Disabled to display the POST messages. Select Enabled to display the
OEM logo instead of the normal POST messages. The options are Enabled and Disabled.
AddOn ROM Display Mode
Use this feature to set the display mode for the Option ROM. Select Keep Current to display
the current AddOn ROM setting. Select Force BIOS to use the Option ROM display set by
the system BIOS. The options are Force BIOS and Keep Current.
Bootup NumLock State
Use this feature to set the Power-on state for the <Numlock> key. The options are Off and On.
Wait For "F1" If Error
Use this feature to force the system to wait until the <F1> key is pressed if an error occurs.
The options are Disabled and Enabled.
4.3 Advanced Setup Congurations
Use the arrow keys to select Boot Setup and press <Enter> to access the submenu items.
To Next Page
Loading...
Need help?
General
