Supermicro X13SEI-TF - Page 100

Super X13SEI-TF/-F User's Manual
100
NVMe Firmware Source
Use this feature to select the NVMe rmware to support booting. The default option, Vendor
Dened Firmware, is pre-installed on the drive and may resolve errata or enable innovative
functions for the drive. The other option, AMI Native Support, is o󰀨ered by the BIOS with a
generic method. The options are VendorDenedFirmware and AMI Native Support.
VGA Priority
Use this feature to select the graphics device to be used as the primary video display for
system boot. The options are Onboard and O󰀨board.
For the following features, note that:
Note 1: The number of slots and slot naming vary based on your motherboard.
Note 2: The Legacy option is available when "Boot Mode Select" is set to Dual.
Note 3: Refer to Boot submenu in BIOS Setup main menu to set "Boot Mode Select."
Onboard Video Option ROM
Select EFI to allow you to boot the computer using the Extensible Firmware Interface (EFI)
device installed on the onboard video port. The options are Disabled, EFI, and Legacy.
CPU SLOT1 PCIe 5.0 x8 OPROM / CPU SLOT2 PCIe 5.0 x8 OPROM/ CPU SLOT4
PCIe 5.0 x16 OPROM / CPU SLOT6 PCIe 5.0 x16 OPROM / CPU SLOT7 PCIe 5.0 x8
OPROM / M.2-C1 OPROM / M.2-C2 OPROM
Select EFI to allow you to boot the computer using the EFI device installed on the PCIe slot
specied. The options are Disabled, Legacy, and EFI.
Onboard SAS Option ROM
Use this feature to enable or disable the onboard SAS rmware to be loaded.
Onboard LAN1 Option ROM
Use this option to select the type of device installed in LAN Port1 used for system boot. The
options are Disabled, PXE, and EFI. Note that options displayed are based on LAN OPROM
ROM.
Onboard NVME0 Option ROM / Onboard NVME1 Option ROM / Onboard NVME2
Option ROM / Onboard NVME3 Option ROM
Use this feature to select which rmware function to be loaded for the NVMe device in this
slot. The options are Disabled, Legacy, and EFI.