Supermicro X13SEI-TF - Page 104

Super X13SEI-TF/-F User's Manual
104
Save Authentication-Key
Use this feature to toggle whether the BIOS should automatically save an Authentication-Key
with the name TPMAuth.bin to a USB ash drive. The options are Disabled and Enabled.
After an Authentication Key is saved, this option will be reset to Disabled. Changes take e󰀨ect
after you save settings and reboot the system.
Note 1: Connect a USB ash drive to your system before conguring this feature. Save
the Authentication-Key and keep a backup.
Note 2: Load the Authentication-Key after installing a TPM device. The TPM function
will not work properly without an Authentication-Key.
USB Security Policy
Use this feature to congure USB Security Policy settings. When this feature has not
previously been set to Enabled, this feature will toggle whether the BIOS should automatically
save a USB Authentication-Key named "USBAuth.bin" to a USB ash drive and begin the
USB Security Policy. The options are Disabled and Enabled. Changes take e󰀨ect after you
save settings and reboot the system.
Note: Connect a USB ash drive to your system before conguring this feature. Save
the USB Authentication-Key and keep a backup.
When this feature has been previously set to Enabled, the options are Enabled and
Reset. To disable the USB Security Policy, set this feature to Reset. When this feature is
set to reset, the system and TCG NVMe devices chosen in "Super-Guardians Protection
Policy" will be in the unprotected mode.
Intel(R) Ethernet Controller X550 - xx:xx:xx:xx:xx:xx
Intel(R) Ethernet Controller X550 - xx:xx:xx:xx:xx:xx
Note 1: This feature is available when "Onboard LAN Option ROM Type" is set to EFI.
Note 2: The Ethernet controller and MAC addresses shown above are based on your
system.
Firmware Image Properties
The following information is displayed:
• Option ROM Version
• Unique NVM/EEPROM ID
• NVM version